Quote from
tpam on January 27, 2025, 11:48 am
Hello again,
I’m facing a little issue with the “printed bevel gear axle screw side” and the dogbone.
I’m with the 406 design so dogbones and rear arms have a 170mm length.
And when I mount those pieces, I have a clash between extremity of the dogbone and the screw into the printed bevel gear axle.
There’s no play for the dogbone and it’s even worse because the hub gets a negative angle. Suspension cannot travel.
I see two possibilities :
- Have a deeper countersink on screw head (and reduce the proposed length of the screw, cause if we don’t we will have the same issue on the nut side)
- Reduce the length of the dogbone on the screw side, but I’m not sure that it won’t generate an issue with the cinematic of the rear axle
Cheers,
Tpam
Hello again,
I’m facing a little issue with the “printed bevel gear axle screw side” and the dogbone.
I’m with the 406 design so dogbones and rear arms have a 170mm length.
And when I mount those pieces, I have a clash between extremity of the dogbone and the screw into the printed bevel gear axle.
There’s no play for the dogbone and it’s even worse because the hub gets a negative angle. Suspension cannot travel.
I see two possibilities :
- Have a deeper countersink on screw head (and reduce the proposed length of the screw, cause if we don’t we will have the same issue on the nut side)
- Reduce the length of the dogbone on the screw side, but I’m not sure that it won’t generate an issue with the cinematic of the rear axle
Cheers,
Tpam
